The big question, we get it. Unfortunately, they are now small, medium, or large. Our cost varies depending on the film you choose, the amount of coverage you want installed, and the vehicle you have (as in the area, think Jeep Wrangler vs F250).  That being said, we unfortunately won't be the cheapest in town either.  Our products are top of the line, our team is even better, and our company stands by both so we pay top tier for both. 

Our films almost always outlive their warranties which range from 5-12 years. Warranties cover yellowing, staining, delaminating, peeling, crackling, bubbling, and more. 

The primary objective is to protect your vehicle from the elements. Whilst a PPF won’t stop a large stone from high speed damaging your vehicle, it will keep it protected from general stone chips and everyday wear and tear. Not only is this good news for aesthetic reasons, it also helps maintain the value of your vehicle by keeping it looking newer than it otherwise would. If the PPF is cared for and remains undamaged, the paint beneath will still look as good as new if you ever get tired of the look and decide to remove the film yourself.

You can use any standard ‘off the shelf’ car wash soap, rinse-free car wash or more specialized detail spray to keep the film clean. However, you must check the label to make sure that your chosen product doesn’t contain more than 5% naphtha or kerosene.

Technically, yes.  We just ask that you wait a full 48 hours before running it through.  If it was us, we'd give a whole 2 weeks.

Ceramic coatings are approved for use with our Paint Protection Films when applied over the surface of the product. Ceramic coatings create an additional barrier for solvent and water penetration while not negatively impacting the performance or self-healing of our Paint Protection Film. This application will not void your warranty.

If a stain doesn’t come off with a regular car wash, try using isopropyl alcohol on a microfiber towel to clean it. If that doesn’t work, you can use a small amount of lacquer thinner. If the stain still remains, we recommend applying an abrasive wax and polishing the surface of the film to restore its original appearance. Polishing or buffing is an effective way to remove contaminants, but it should only be done as needed or once every 12-18 months. A good example of a mild-abrasive wax is Turtle Wax Renew RX Polishing Compound (Light to Medium Cleaner)

In an ideal situation, an installer will have the vehicle for 24 hours to monitor the film for any lifting edges before releasing the vehicle to the owner. In situations where this is not possible, we strongly recommend at least a 2-3 hour waiting period indoors followed by an inspection to ensure all edges are sealed before the vehicle is released.

LLumar Paint Protection Film contains a proprietary top coat. This top coat protects the urethane against surface scratches. The majority of surface scratches will self-heal when exposed to heat – sun, warm panel (motor running), warm water, etc. We demonstrate this with a copper wire brush to simulate surface scratches that will self-heal such as surface dirt, sand, salt, etc.

Film should be lifted at a 45-degree angle and pulled towards yourself; this will cause the adhesive to release. Do Not fold the film over on itself and rip it off, this can leave adhesive behind. In cold-weather environments, we recommend a steamer to aid in softening the film/adhesive for removal.